Remove The Motor Clutch Assembly (P/N 2309067); Figure 6-22: Mark The Secondary Base Drive Belt; Figure 6-23: Disassemble Secondary Base Positioning Belt - GE Discovery LS System Service Manual

GE
HEALTHCARE
D 2307224-100, R
IRECTION EVISION
6.2.5.10

Remove the Motor Clutch Assembly (P/N 2309067)

For best results, check the table and secondary base with a level before removing the motor clutch
assembly. Check level again, before fastening the covers into place. If necessary, adjust the table
levelers to re-level the table and secondary base.
To disassemble the secondary base drive belt:
1.) Refer to
the edges of the belt connector before disassembling the belt.
2.) Refer to
from the fastener plate, and set aside.
3.) Remove the fastener plate and set aside.
4.) Remove the drive belt from the pulley on the motor clutch assembly.
6
Figure 6-22. Use two strips of masking tape, or some white correction fluid, to mark

Figure 6-22: Mark the Secondary Base Drive Belt

Figure 6-23. Use a 4 mm Allen wrench to remove the four socket-head cap screws
Socket-Head Cap Screws (4) and Fastener Plate

Figure 6-23: Disassemble Secondary Base Positioning Belt

Chapter 6 - Table
D LS S S
ISCOVERY YSTEM ERVICE
Page 129
M
ANUAL