Install The Table Bulkhead (If Necessary); Figure 6-40: Install Table Bulkhead Bracket, P/N 2309772 - GE Discovery LS System Service Manual

GE
HEALTHCARE
D 2307224-100, R
IRECTION EVISION
3.) Use a 13 mm or 1/2 inch socket to reattach the new assembly to the secondary base.
a.) Fasten the motor clutch assembly to the right secondary base side rail with five bolts.
b.) Fasten the motor clutch assembly to the left secondary base side rail with four bolts.
4.) Slightly loosen the spreader hardware.
5.) Remove the C-clamps.
6.) Follow local guidelines to recycle or discard the spreader bar assembly.
6.2.6.11

Install the Table Bulkhead (If Necessary)

Early ME1 tables do not have a bulkhead, so the kit ships with a new table bulkhead. If the system
already has a bulkhead, do not replace it.
1.) If necessary, locate and remove the following hardware from the upgrade kit:
2309772
46-328417P13
2315373-4
2109878-3
2.) Refer to
M6 socket-head cap screws, flats and lock washers.
Note: For best results, temporarily remove the bulkhead, attach the Cable P/N 2323724 to the back side
of the bulkhead, then fasten the bulkhead into place.
6
Part Number
Table Bulkhead Bracket
M6 x 16 mm Socket-Head Cap Screw
M6 Lock Washer
M6 Flat Washer
Figure 6-40. Use a 5 mm Allen wrench to fasten the table bulkhead in place with two

Figure 6-40: Install Table Bulkhead Bracket, P/N 2309772

Chapter 6 - Table
D
ISCOVERY
Description
Rear Side of Bulkhead
LS S S M
YSTEM ERVICE ANUAL
Quantity
1
2
2
2
Page 143