Preparing The Gantry For Adjustment; Figure 8-13: High-Load Rollers; Figure 8-14: Linear Bearing Assembly Adjuster Screws And Baseplate Screws - GE Discovery LS System Service Manual

GE H
EALTHCARE
D 2307224-100, R
IRECTION EVISION
4.) Loosen the screws on the driving assembly holding bracket (shown in
remove the holding bracket from the leg of the gantry enabling the gantry to move freely along
its transport rails.
5.) Close the adjuster of the rear high-load roller (shown in
leaving only the front high-load roller in contact with the baseplate.
8.1.2.3

Preparing the Gantry for Adjustment

1.) Release the adjuster securing screw from each linear bearing assembly adjuster (shown in
Figure
Holding Bracket
Screws
Page 254
6

Figure 8-13: High-Load Rollers

8-14).

Figure 8-14: Linear Bearing Assembly Adjuster Screws and Baseplate Screws

Chapter 8 - System QC, Calibration and Functional Tests
D
ISCOVERY
Figure 8-13) to lift it from the baseplate,
Adjuster Closed
Linear Bearing Assembly Adjusters
Adjuster Assembly
LS S S M
YSTEM ERVICE ANUAL
Figure 8-14), and
Baseplate Screws
Adjuster
Securing
Screw