Figure 6-33: Pet Drill Template (Exterior View) - GE Discovery LS System Service Manual

GE H
EALTHCARE
D 2307224-100, R
IRECTION EVISION
4.) Refer to
of M6 hardware.
5.) Use a 5 mm Allen wrench to tighten the M6 hardware.
CAUTION To prevent injury, wear eye protection while drilling.
6.) Tape a piece of paper or paper towel to the interior of the rail, to prevent the debris from
collecting on the bearing rail.
7.) Use a 5.5 mm bit to drill the template holes. (Do not tap these holes.)
• Recommended: Use cutting oil when drilling.
• Keep the drill perpendicular to the rail while drilling.
• Stop frequently to let the drill bit cool.
• Vacuum debris while drilling.
Page 138
6
Figure 6-33. Fasten the template into place with the two clamp blocks and four sets

Figure 6-33: PET Drill Template (Exterior View)

Chapter 6 - Table
Drill these four holes.
D LS S S
ISCOVERY YSTEM ERVICE
M
ANUAL