Install The New Clutch Motor Assembly; Figure 6-38: 20 Mm Offset Drill Holes; Figure 6-39: Support The Clutch Motor Assembly With Wood - GE Discovery LS System Service Manual

GE H
EALTHCARE
D 2307224-100, R
IRECTION EVISION
5.) Vacuum all debris from the area.
6.2.6.10

Install the New Clutch Motor Assembly

CAUTION Refer to
pulleys is loose on the shaft when installing the motor clutch assembly. Use a 1.5 mm Allen
wrench to loosen the set screws.
Set screws located
on Pulley next to
potentiometer (blue).
1.) Reuse the bolts removed during the Section
2.) Set the clutch motor casting on a piece of wood and slide it into place.
Page 142
6
These holes shift the PET detent 20 mm closer to the CT detent.

Figure 6-38: 20 mm Offset Drill Holes

Figure 6-39.To prevent damage to the system, always make sure at least one of the

Figure 6-39: Support the Clutch Motor Assembly with Wood

Chapter 6 - Table
D
These holes shift the PET detent adjuster 20 mm.
6.2.5.10 procedure.
LS S S M
ISCOVERY YSTEM ERVICE ANUAL