Install The Roller Cover Assembly; Attach The Roller Cover Guides To The Secondary Base Side Rails; Figure 6-113: Assemble The Roller Cover Guides - GE Discovery LS System Service Manual

GE
HEALTHCARE
D 2307224-100, R
IRECTION EVISION
6.2.7.3

Install the Roller Cover Assembly

CAUTION The roller canister is too small to accommodate a cover long enough to stretch to the service
position. After the roller cover assembly is installed and the roller cover attached to the
bracket on the table, REMEMBER to detach the cover each time the table is moved to the
service position. Refer to
the center hole in the top cover to prevent the cover from retracting into the canister.
6.2.7.4

Attach the Roller Cover Guides to the Secondary Base Side Rails

Refer to
guide, and the narrow rail provides the bottom guide. Follow the procedure in this section to align
the holes and fasten the rails to the secondary base with M4 hardware.
1.) Locate and remove the following parts from the upgrade kit:
Part Number
2342802
2342802-2
2103580-6
46-328430P2
46-328432P2
46-328425P1
2.) Assemble the guides as shown in
6
Figure
Figure 6-113. The cover guide consists of two rails. The wide rail provides the top cover

Figure 6-113: Assemble the Roller Cover Guides

Bracket Rail, Upper (Wide Guide)
Bracket Rail, Lower (Narrow Guide)
M4 x 25 Flat-Head Screw
M4 Flat Washer
M4 Lock Washer
M4 Hex Nut
Chapter 6 - Table
6-126. Insert a screwdriver blade, or fasten a bolt through
Description
Figure 6-113.
D LS S S
ISCOVERY YSTEM ERVICE
Quantity
2
2
4
4
4
4
Page 191
M
ANUAL