Troubleshooting And Maintenance; Safety Information; Cleaning The Device - 3D Histech Pannoramic DESK II User Manual

Table of Contents

Pannoramic DESK II 1.22 User's Guide

5 Troubleshooting and Maintenance

Check cables, plugs and connections before operation, and if defective or cannot be replaced, contact

3DHISTECH Service for support.

Check whether the device is compatible with your local line voltage. It can operate at line voltages

100V to 240V and 50/60 Hz.

Only plug the device in a socket with protective grounding (earth) contact.

Do not operate the device in explosive environment.

Disconnect the device from the power outlet before opening it or replacing a part.

The product is not equipped with protection against hazardous materials (infectious, toxic,

radioactive, corrosive substances or other effects damaging to health). Decontaminate infectious

materials after use.

Dust, specks and humidity may decrease or harm the operating capability of the device. Protect it

with dust cover when not in use. Switch the power off before covering it.

Avoid touching the lamp bulb. Wait for about 15 minutes to allow the bulb to cool down and

disconnect the power plug before changing the bulbs.

Defective devices do not classify as domestic waste. Dispose of the device in compliance with the

currently valid legal requirements.

Before cleaning, switch off the device and pull the plug out.

Do not let liquid penetrate into the system.

To clean liquid from the device, use a lint-free cotton cloth. You can moisten the cloth with water.

To clean greasy surfaces, it is recommended to apply Isopropanol or Ethanol on a piece of lint-free

cotton cloth and gently rub the surface.

June 24, 2016 - Rev. 1

3DHISTECH Ltd.

5 Troubleshooting and Maintenance

64(76)

Table of Contents