Boom Manifold Valve Assembly - Toro Multi Pro 5800 Service Manual

Boom Manifold Valve Assembly

FRONT
RIGHT
5
3
2
12
15
15
1. RH boom valve motor
2. O- -ring
3. Mounting bracket (2 used)
4. Center boom valve motor
5. LH boom valve motor
IMPORTANT: Boom valve motors have a fuse for
circuit protection. Make sure that correct fuse is
installed in the in- -line fuse holder located in the
boom valve motor harness.
The boom control switches on the operator spray con-
sole are used to energize the boom valve motors and
open the boom valves. The open boom valves allow sys-
tem flow to reach the appropriate boom section (right,
center or left).
Spray System
4
8
7
13
14
6. Cap screw (4 used)
7. O- -ring (6 used)
8. Fork (6 used)
9. Valve cap (3 used)
10. Pressure gauge port
Page 6 - - 22
1
2
11
7
9
Figure 17
NOTE: If your Multi Pro is equipped with the manual in-
terface control, a manually adjustable boom bypass
valve must be incorporated in each of the boom control
valves (Fig. 19). The balancing valve assembly should
not be used on vehicles with a Pro Control XP Spray
System.
6
3
10
14
8
NOTE: ARROWS SHOW FLUID
FLOW DIRECTION
11. Adapter
12. Flange
13. Hosebarb (3 used)
14. Washer (4 used)
15. Lock nut (4 used)
Multi Pro 5800
6