Engine Installation - Toro Multi Pro 5800 Service Manual

IMPORTANT: During hydraulic pump removal, sup-
port pump assembly to prevent it from falling and
being damaged.
9. Remove hydraulic pump assembly from engine (see
Piston (Traction) Pump Removal in the Service and Re-
pairs section of Chapter 4 -- Hydraulic System).
10.Remove throttle cable from injector pump (Fig. 15):
A. Loosen screw that secures cable stop on throttle
cable. Slide cable stop from cable.
B. Loosen cable clamp and remove throttle cable
from under clamp.
C. Slide cable end out of swivel and position throttle
cable away from the engine.
11. Note location of any cable ties used to secure the wir-
ing harness, fuel lines or hydraulic hoses to the engine
assembly. Remove cable ties attached to engine as-
sembly.
IMPORTANT: During engine removal, support en-
gine assembly to prevent it from falling and being
damaged.
12.Remove flange nuts, snubbing washers and cap
screws securing the engine brackets to the machine
frame.
CAUTION
Make sure that hoist or lift used to remove en-
gine can properly support engine. Engine as-
sembly weighs approximately 275 pounds (125
kg).
IMPORTANT: Make sure to not damage the engine,
fuel hoses, hydraulic lines, electrical harness or
other parts while removing the engine assembly.
13.Using a hoist or lift, carefully lower engine from the
machine.
14.If necessary, remove engine brackets from the en-
gine and engine mounts from frame.
Engine Installation (Fig. 10)
1. Locate machine on a level surface with key removed
from the ignition switch. Raise machine to allow engine
to be raised into frame.
2. Make sure that all parts removed from the engine
during maintenance or rebuilding are reinstalled to the
engine.
Kubota Diesel Engine
2
3
1. Alternator
2. Alternator stud
1
4
1. Fuel stop solenoid
2. Fuel supply hose
3. Water/fuel filter
1. Cable stop
2. Throttle swivel
3. Throttle cable
4. Washer head screw
Page 3 - - 14
1
Figure 13
3. Harness connector
3
5
Figure 14
4. Throttle cable
5. Fuel pump
1
2
7
3
5
6
4
Figure 15
5. Cable clamp
6. Lock nut
7. Cable bracket
Multi Pro 5800
2