Boom Lift Control Manifold - Toro Multi Pro 5800 Service Manual

Boom Lift Control Manifold

8
4
5
1. Flange nut (2 used)
2. Cover plate
3. Flange nut (2 used)
4. Boom lift cylinder (2 used)
Removal (Fig. 71)
1. Park the machine on a level surface, fully lower the
spray booms, engage the parking brake and stop the
engine. Remove the key from the ignition switch.
WARNING
Make sure that spray booms are fully lowered be-
fore loosening hydraulic lines, cartridge valves
or plugs from lift control manifold. If booms are
not fully lowered as manifold components are
loosened, booms may drop unexpectedly.
Hydraulic System
10
11
9
5. Boom valve mount plate
6. Cap screw (2 used)
7. Boom lift control manifold
8. Hydraulic hose (4 used)
1
2
3
7
6
4
Figure 71
Rotate steering wheel and depress traction ped-
al in both forward and reverse to relieve hydrau-
lic system pressure and to avoid injury from
pressurized hydraulic oil.
2. Operate all hydraulic controls to relieve hydraulic
system pressure.
3. Read the General Precautions for Removing and
Installing Hydraulic System Components at the begin-
ning of the Service and Repairs section of this chapter.
Page 4 - - 90
FRONT
RIGHT
9. Cylinder mount plate
10. Dust cap
11. Test fitting
CAUTION
Multi Pro 5800