Installing The Boom Assembly; Center-Boom Assembly; Bolt (3/8 X 1 Inch); Locknut (3/8 Inch) - Toro Multi Pro WM 41240 Operator's Manual

8

Installing the Boom Assembly

Parts needed for this procedure:
1

Center-boom assembly

10

Bolt (3/8 x 1 inch)

10

Locknut (3/8 inch)

2

Boom-transport cradle

4

Bolt (1/2 x 1-1/4 inches)

4

Flange nut (1/2 inch)

1

Left boom extension

1

Right boom extension

Procedure
1. Locate and remove the center boom assembly from
packaging.
2. Mount the center boom assembly through the third
hole from the bottom of the brackets on the spray
system assembly, as shown in Figure 19, with 4 bolts
(1/2 x 1-1/4 inches) and 4 locknuts (1/2 inch).
Note: If necessary, the boom frame mounts can be
loosened and adjusted at the center boom assembly
for better hole alignment.
G022357
Figure 19
1. Locknut (1/2 inch)
3. Install the boom transport cradles to the center boom
using 6 bolts (3/8 x 1 inch) and 6 locknuts (3/8 inch).
Note: Orient them as shown in Figure 20.
2
1
2. Bolt (1/2 x 1-1/4 inches)
1. Boom-transport cradle
2. Bolts (3/8 x 1 inch)
4. Remove the quick connect hose connections from the
hydraulic bed lift cylinders, and connect them to the
boom lift cylinder.
5. Connect the wiring harness to the hydraulic block as
shown in Figure 21.
1. Right up solenoid
2. Right down solenoid
3. Left down solenoid
6. Remove the 4 bolts, 4 washers and 4 nuts on the hinge
plate.
7. Install the extension boom to the center boom at the
hinge plate using 4 bolts, 4 washers and 4 nuts removed
in step 6 as shown in Figure 22.
18
1
2
3
Figure 20
3. Locknuts (3/8 inch)
Figure 21
4. Left up solenoid
5. Enable solenoid
G022356