Toro Multi Pro 5800 Service Manual page 29

Removal (Fig. 7)
CAUTION
The muffler and exhaust system may be hot. To
avoid possible burns, allow the engine and ex-
haust system to cool before working on the ex-
haust system.
1. Park machine on a level surface, stop engine, en-
gage parking brake and remove key from the ignition
switch.
2. Support muffler from below to prevent it from falling.
3. Remove exhaust system components as required
using Fig. 7 as a guide. During removal, note location of
fasteners in rubber exhaust system hangers so hangers
are properly assembled.
4. Locate and retrieve muffler gasket if exhaust pipe
was removed.
5. Remove hangers and brackets from exhaust com-
ponents as needed.
Multi Pro 5800
Installation (Fig. 7)
IMPORTANT: If exhaust studs were removed from
engine cylinder head, thoroughly clean threads in
head and apply Loctite #277 (or equivalent) to stud
threads before installing studs into head.
1. Install all removed hangers and brackets to exhaust
components.
2. Make sure that gasket surfaces on engine exhaust
manifold and exhaust pipe are clean.
3. Install all removed exhaust system components us-
ing Fig. 7 as a guide.
A. During exhaust installation, finger tighten all ex-
haust system components before fully tightening
any of the fasteners.
B. Install rubber exhaust system hangers as noted
during exhaust system removal.
C. Make sure that tailpipe outlet is parallel to the
ground.
D. Tighten muffler clamps last to secure exhaust
components.
Page 3 - - 9 Kubota Diesel Engine