Neutral Switch - Toro Multi Pro 5800 Service Manual

Neutral Switch

The neutral switch is located on the top side of the piston
(traction) pump (Fig. 35). The switch is closed when the
1
traction pedal is in the neutral position and opens when
2
the pedal is depressed in either direction (forward or re-
verse).
Test the switch by disconnecting the wire harness con-
nector from the switch and connecting a continuity tester
across the two (2) switch terminals. With the engine
turned off, slowly push the traction pedal in a forward or
reverse direction while watching the continuity tester.
There should be indications that the traction neutral
switch is opening and closing. Allow the traction pedal
to return to the neutral position. There should be conti-
nuity across the switch terminals when the traction ped-
al is in the neutral position.
Figure 35
See Piston (Traction) Pump Service in the Service and
1. Piston (traction) pump 2. Neutral switch
Repairs section of Chapter 4 -- Hydraulic Systems for
disassembly, assembly and adjustment procedures for
the neutral switch.
Electrical System Page 5 - - 24 Multi Pro 5800