Toro Multi Pro 5800 Service Manual page 211

Removal (Fig. 29)
IMPORTANT: Make sure to remove and neutralize
chemicals from spray components before disas-
sembly. Wear protective clothing, chemical resist-
ant gloves and eye protection during repair.
1. Park machine on a level surface, stop engine, en-
gage parking brake and remove key from the ignition
switch.
2. Loosen hose clamps and remove supply hose(s)
from turret body.
3. Remove flange nut (item 6) that secures turret body
to spray boom. Remove turret body from machine.
Multi Pro 5800
Installation (Fig. 29)
NOTE: The type of hose barb on turret body deter-
mines turret location on spray boom. Refer to Figure 29
for turret position on booms.
1. Position turret body to bracket on spray boom. Make
sure that spray nozzle and nozzle fan slot are parallel to
ground. Install and tighten flange nut to secure turret
body.
2. Install supply hose(s) to turret body and secure with
hose clamp(s).
Page 6 - - 33 Spray System