Speed Lock Switch - Toro Multi Pro 5800 Service Manual

Speed Lock Switch

The speed lock switch is located on the console assem-
bly (Fig. 12). This switch energizes the speed lock coil
to allow the operator to maintain a constant ground
speed. The switch includes a light that should be illumi-
nated when the switch is in the ON position.
Testing
1. Remove LH console cover to gain access to speed
lock switch (see Console Assembly in the Service and
Repairs section of Chapter 7 -- Chassis).
2. Make sure ignition switch is off. Disconnect the wire
harness electrical connector from the speed lock switch.
3. The switch terminals are marked as shown in Figure
13. In the ON position, continuity should exist between
terminals 2 and 3. In the momentary SET position, conti-
nuity should exist between terminals 5 and 6. In the OFF
position, there should be no continuity between any
switch terminals.
4. Terminals 7 (--) and 8 (+) are used for the indicator
light in the switch. The light should be illuminated when
the switch is in the ON position.
5. To test switch light, apply 12 VDC to terminal 8 (+)
and ground terminal 7 (--). The light should illuminate.
6. Replace switch if necessary.
7. Connect the wire harness connector to the switch af-
ter testing is complete.
8. Secure LH console cover to machine (see Console
Assembly in the Service and Repairs section of Chapter
7 -- Chassis).
Electrical System
2
1
1. Console assembly
Page 5 - - 12
Figure 12
2. Speed lock switch
7 5 6
8 2 3
BACK OF SWITCH
Figure 13
Multi Pro 5800