Toro Multi Pro 5800 Service Manual page 213

Disassembly (Fig. 30)
IMPORTANT: Make sure to remove and neutralize
chemicals from spray components before disas-
sembly. Wear protective clothing, chemical resist-
ant gloves and eye protection during repair.
1. Pull e--clip from body and slide plug with O--ring from
body.
2. Disassemble turret body using Figure 30 as a guide.
3. Discard all removed seals, gaskets, O--rings and dia-
phragms.
Assembly (Fig. 30)
NOTE: Seal kits for turret body service are available.
Seal kit part number 108--3266 includes an O--ring (item
14) and seal (item 15). Seal kit part number 108--3267
includes a diaphragm (item 18) and four (4) O--rings
(items 2, 9 and 13).
NOTE: Coat all O--rings with vegetable oil before instal-
lation to reduce the chance of damage during assembly.
1. Replace all removed seals, gaskets, O--rings and di-
aphragms.
2. Assemble turret body using Figure 30 as a guide.
A. The turret (item 8) end with slightly larger bore
and detent grooves needs to be orientated toward
detent posts on body (item 4) (Fig. 31).
B. Make sure to align notch on plug (item 10) with
groove in body (item 4) as plug is installed.
C. Install e--clip (item 5) into body to secure assem-
bly.
Multi Pro 5800
1
2
1. Body
2. Detent post
Page 6 - - 35
3
2
Figure 31
3. Detent groove
Spray System