Adjustments - Toro Multi Pro 5800 Service Manual

Adjustments

Adjust Throttle Cable
Proper throttle operation is dependent upon proper ad-
justment of throttle cable.
NOTE: The throttle cable swivel should be positioned
in the lowest hole in the speed control lever.
1. Move throttle control lever on control console to
FAST position.
2. Check position of the engine speed control lever on
fuel injection pump. The speed control lever should be
contacting the high speed screw when the throttle con-
trol lever is in the FAST position.
3. If necessary, throttle cable can be adjusted by loos-
ening cable clamp screw and repositioning cable until
speed control lever contacts high speed screw when the
throttle control lever is in the FAST position. Tighten
cable clamp screw after adjustment has been com-
pleted.
4. After securing cable clamp, make sure that cable ad-
justment is still correct.
Multi Pro 5800
1
5
1. Throttle cable
2. High speed screw
3. Speed control lever
1. Lock nut
2. Cable stop
3. Throttle swivel
4. Throttle cable
Page 3 - - 3
2
3
4
Figure 1
4. Throttle swivel
5. Cable clamp
1
2
3
8
4
7
6
5
Figure 2
5. Washer head screw
6. Cable clamp
7. Lock nut
8. Cable bracket
Kubota Diesel Engine