Headlight Switch - Toro Multi Pro 5800 Service Manual

Headlight Switch

The headlight switch is located on the left side of the
console assembly (Fig. 10) and is used to turn the head-
lights on and off.
Testing
1. Remove LH console cover to gain access to head-
light switch (see Console Assembly in the Service and
Repairs section of Chapter 7 -- Chassis).
2. Make sure ignition switch is off. Disconnect the wire
harness electrical connector from the headlight switch.
3. With the use of a multimeter (ohms setting), the
switch functions may be tested to determine whether
continuity exists between the various terminals for each
position. The switch terminals are marked as shown in
Figure 11. The circuitry of the headlight switch is shown
in the chart below. Verify continuity between switch ter-
minals.
SWITCH NORMAL
POSITION CIRCUITS
ON
OFF
4. Replace switch if necessary.
5. Connect the wire harness connector to the switch af-
ter testing is complete.
6. Secure LH console cover to machine (see Console
Assembly in the Service and Repairs section of Chapter
7 -- Chassis).
Multi Pro 5800
OTHER
CIRCUITS
2 + 3 5 + 6
2 + 1 5 + 4
Page 5 - - 11
1
2
Figure 10
1. Console assembly
BACK OF SWITCH
Figure 11
NOTE: Headlight switch terminals 1, 4, 5 and 6 are not
used on Multi Pro 5800 machines.
2. Headlight switch
Electrical System