Toro Multi Pro 5800 Service Manual page 245

Disassembly (Fig. 19)
1. Park machine on a level surface, stop engine, en-
gage parking brake and remove key from the ignition
switch.
2. Loosen latches and remove access cover from out-
side of console assembly.
3. At front of console assembly, remove screw (item 28)
and lock nut (item 19) that secure console arm covers
to each other.
4. Remove five (5) washer head screws (item 9) that
secure each cover to console assembly.
5. Remove console assembly covers from machine. As
LH console cover (item 17) is removed from console as-
sembly, unplug wire harness connector from headlight
switch.
6. Remove components from console assembly as
needed using Figures 19 and 20 as guides.
Assembly (Fig. 19)
1. Install all removed components to console assembly
using Figures 19 and 20 as guides.
2. Position covers to console assembly. As LH cover
(item 17) is placed, plug wire harness connector to
headlight switch. Also, make sure that wire harness and
throttle control cable are routed correctly through cover
openings.
3. Secure each cover to console assembly with five (5)
washer head screws (item 9). Install screw (item 28) and
lock nut (item 19) to secure covers at front of console as-
sembly.
4. Install access panel to outside of console assembly.
Multi Pro 5800
1
8
7
1. Speed lock switch
2. Agitation switch
3. Pump switch
4. RH boom lift switch
Page 7 − 29
2
3
4
5
6
Figure 20
5. RH boom switch
6. Center boom switch
7. LH boom switch
8. LH boom lift switch
Chassis