Checking The Outer Boom Cradles - Toro Multi Pro 5800-D Operator's Manual

1. Section-hinge spring
2. Jam nut
4. Repeat the procedure for each spring on both
section hinges.
5. Move the sections into the transport 'X' position.
See Changing the Spray Section Position (page
39) for more information.
3
Checking the Outer Boom
Cradles
No Parts Required
Procedure
1. Engage the parking brake and start the engine,
and set the throttle to idle.
2. Slowly raise the left or right outer boom until it
first contacts the upper cradle tube.
3. Slowly raise the other outer boom until it first
contacts the cradle.
4. Look at the area on the upper cradle tubes
where the slide blocks on the top tube of the
outer boom contact the cradles.
Figure 5
3. Compressed spring
dimension—39.7mm
(1-9/16 inches)
Note:
The cradle is adjusted correctly when
the blocks contact the cradle at the bend in the
upper cradle tube
g035648
5. If either upper cradle tube is misaligned with
the slide block as shown in
or Figure
Aligning the Cradles to the Outer Booms (page
77).
The upper cradle tube is aligned behind slide block.
1. Slide block
14
(Figure 6).
Figure 6
Figure
9, adjust the cradle position; refer to
Figure 7
2. Upper cradle tube
g354255
7, Figure 8,
g354256