Table of Contents
Advertisement
AT commands
Parameter range
0 - 0xFFFF
Default
0x11 (Transparent data cluster ID)
DE command
Sets or displays the application layer destination ID value. The value is used as the destination
endpoint for all data transmissions. The default value (0xE8) is the Digi data endpoint.
Parameter range
0 - 0xFF
Default
0xE8
SE (Source Endpoint)
Sets or displays the application layer source endpoint value. The value is used as the source endpoint
for all data transmissions. The default value (0xE8) is the Digi data endpoint.
Parameter range
0 - 0xFF
Default
0xE8
Diagnostic - addressing commands
The following AT command is a Diagnostic - addressing command.
N? (Network Discovery Timeout)
The maximum response time, in milliseconds, for ND (Network Discovery) responses and DN (Discover
Node) responses. The timeout is based on the NT (Network Discovery Back-off Time) and the network
propagation time.
Parameter range
[read-only]
Default
0x3D6A
Addressing discovery/configuration commands
AG (Aggregator Support)
The AG command sends a broadcast through the network that has the following effects on nodes that
receive the broadcast:
XBee/XBee-PRO DigiMesh 2.4 RF Module User Guide
Diagnostic - addressing commands
82
Advertisement
Table of Contents
