Analog I/O Connector (J10); Table 2-39: Analog I/O Connector Pinout (J10); Table 2-40: Mating Connector Part Numbers For The Analog I/O Connector (J10) - Aerotech Npaq DL 4010 Series Hardware Manual

Installation and Configuration

2.10. Analog I/O Connector (J10)

The Analog I/O Connector (J10) is a 15-pin 'D' style connector located on the Rear Panel Interface board and
is accessible at the rear of the Npaq chassis. The Analog I/O interface provides the user with four differential
16-bit analog inputs and two single-ended 16-bit analog outputs.
the analog outputs.
Table 2-39: Analog I/O Connector Pinout (J10)
Pin # Description
1 Analog Input 0+
2 Analog Input 1+
3 Analog Input 2+
4 Analog Input 3+
5* +5 Volts
6 Analog Output 0
7 Analog Ground
8 Analog Ground
9 Analog Input 0-
10 Analog Input 1-
11 Analog Input 2-
12 Analog Input 3-
13 Not Used
14 Analog Output 1
15 Analog Ground
* Pin 5 is unused on Npaq's produced before February 2009.
Table 2-40: Mating Connector Part Numbers for the Analog I/O Connector (J10)
Mating Connector
15-Pin D-Connector
Backshell
N O T E : Analog inputs 2 and 3 are required for Joystick operation. They will not be otherwise accessible if
a joystick option is present (see
jumper configured (see
www.aerotech.com
Section 2.11.). If a joystick option is present, AIN2 and AIN3 must be
Table 4-8) as single ended inputs.
Chapter 2
Npaq® Hardware Manual
Table 2-41 provides the specifications for
Aerotech P/N
ECK00100
ECK01022
In/Out/Bi Connector
Input
Input
Input
Input
Output
Output
N/A
N/A
Input
Input
Input
Input
N/A
Output
N/A
Third Party P/N
Amphenol DA15P064TXLF
Amphenol 17E-1725-2
75