Aerotech Npaq DL 4010 Series Hardware Manual page 110

Npaq® Hardware Manual
Table 4-7: Drive Interface Jumper Settings
Jumpers Positions
BW1
BW2
BW10, 11, 12
BW20, 21, 22
BW30, 31, 32
BW40, 41, 42
BW50, 51, 52
JP1
* default
110
Function
In Bus #1 Uni-polar supply only
Out * Bus #1 Uni-polar / Bipolar supply
In Bus #2 Uni-polar supply only
Out * Bus #2 Uni-polar / Bipolar supply
In * Connects Bus Supply (B-, RTN, B+) between Axis 1 and 2
Out Splits Bus Supply (B-, RTN, B+) between Axis 1 and 2
In * Connects Bus Supply (B-, RTN, B+) between Axis 2 and 3
Out Splits Bus Supply (B-, RTN, B+) between Axis 2 and 3
In * Connects Bus Supply (B-, RTN, B+) between Axis 3 and 4
Out Splits Bus Supply (B-, RTN, B+) between Axis 3 and 4
In * Connects Bus Supply (B-, RTN, B+) between Axis 4 and 5
Out Splits Bus Supply (B-, RTN, B+) between Axis 4 and 5
In * Connects Bus Supply (B-, RTN, B+) between Axis 5 and 6
Out Splits Bus Supply (B-, RTN, B+) between Axis 5 and 6
In * Disable Axis power monitor for Brake
Enable Axis power monitor for Brake (Additional wiring and hardware is
Out
required)
Chapter 4
Maintenance
www.aerotech.com