Safety Procedures And Warnings - Aerotech Npaq DL 4010 Series Hardware Manual

Electrical Safety

Safety Procedures and Warnings

This manual tells you how to carefully and correctly use and operate the Npaq. Read all parts of this manual
before you install or operate the Npaq or before you do maintenance to your system. To prevent injury to you
and damage to the equipment, obey the precautions in this manual. The precautions that follow apply when
you see a Danger or Warning symbol in this manual. If you do not obey these precautions, injury to you or
damage to the equipment can occur. If you do not understand the information in this manual, contact
Aerotech Global Technical Support.
This product has been designed for light industrial manufacturing or laboratory environments. The protection
provided by the equipment could be impaired if the product is used in a manner not specified by the
manufacturer.
N O T E : Aerotech continually improves its product offerings; listed options may be superseded at any
time. All drawings and illustrations are for reference only and were complete and accurate as of this
manual's release. Refer to www.aerotech.com for the most up-to-date information.
D A N G E R : This product contains potentially lethal voltages. To reduce the possibility of
electrical shock, bodily injury, or death the following precautions must be followed.
1. Ensure that all electrical power switches are in the off position when servicing the
equipment.
2. Disconnect electrical power before servicing equipment.
3. Disconnect electrical power before performing any wiring.
4. Access to the Npaq and component parts must be restricted while connected to a power
source.
5. Residual voltages greater than 60V may be present inside Npaq chassis for longer than 10
seconds after power has been disconnected.
6. To minimize the possibility of electrical shock and bodily injury, extreme care must be
exercised when any electrical circuits are in use. Suitable precautions and protection must
be provided to warn and prevent persons from making contact with live circuits.
7. Install the Npaq inside a rack or enclosure.
8. Do not connect or disconnect any electrical components or connecting cables while
connected to a power source.
9. All components must be properly grounded in accordance with local electrical safety
requirements.
10. Operator safeguarding requirements must be addressed during final integration of the
product.
D A N G E R / H E A V Y : To avoid injury, use two or more people to move and install this
product.
Refer to
l
Use a cart to move the product.
l
Do not use the handles on the front of the product to lift or move this product. Use the
l
handles only to slide the product in and out of its enclosure.
Lift this product only by the base. Do not use the cables or the connectors to lift or move
l
this product.
www.aerotech.com
Section 1.2. for chassis mass specifications.
Npaq® Hardware Manual
11