Aerotech Npaq DL 4010 Series Hardware Manual page 112

Npaq® Hardware Manual
Table 4-8: Rear Panel Interface Board Jumper Information
Jumpers Positions
1-2 *
JP1
2-3
1-2 *
JP2
2-3
1-2 *
JP3
2-3
1-2 *
JP4
2-3
1-2 *
JP5
2-3
1-2 *
JP6
2-3
In *
JP7
Out
1-2 *
JP8
2-3
1-2 *
JP9
2-3
1-2 *
JP10
2-3
1-2 *
JP11
2-3
1-2 *
JP12
2-3
1-2 *
JP13
2-3
In *
JP14
Out
In *
JP15
Out
1-2 *
JP16
2-3
* default
Table 4-9: Rear Panel Interface Board Test Points
Test Point Function
TP4 Common
TP5 Setup 1
TP6 Setup 2
TP7 Setup 3
TP8 Setup 4
TP9 Setup 5
TP10 Setup 6
112
Function
Axis 1 Limit supply is +5 Volts (1-2 is trace)
Axis 1 Limit supply from (Internal) J16 (Cut trace 1-2)
Axis 2 Limit supply is +5 Volts (1-2 is trace)
Axis 2 Limit supply from (Internal) J16 (Cut trace 1-2)
Axis 3 Limit supply is +5 Volts (1-2 is trace)
Axis 3 Limit supply from (Internal) J16 (Cut trace 1-2)
Axis 4 Limit supply is +5 Volts (1-2 is trace)
Axis 4 Limit supply from (Internal) J16 (Cut trace 1-2)
Axis 5 Limit supply is +5 Volts (1-2 is trace)
Axis 5 Limit supply from (Internal) J16 (Cut trace 1-2)
Axis 6 Limit supply is +5 Volts (1-2 is trace)
Axis 6 Limit supply from (Internal) J16 (Cut trace 1-2)
+5 Volt minimum load (System has less than 3 axes)
System has more than 3 axes
N/A: Internal Aerotech Use Only
N/A: Internal Aerotech Use Only
N/A: Internal Aerotech Use Only
N/A: Internal Aerotech Use Only
N/A: Internal Aerotech Use Only
N/A: Internal Aerotech Use Only
N/A: Internal Aerotech Use Only
N/A: Internal Aerotech Use Only
N/A: Internal Aerotech Use Only
N/A: Internal Aerotech Use Only
N/A: Internal Aerotech Use Only
N/A: Internal Aerotech Use Only
Analog Input 2 set for single-ended input (Joystick)
Analog Input 2 set for differential input
Analog Input 3 set for single-ended input (Joystick)
Analog Input 3 set for differential input
PSO Opto Output configured as normally open
PSO Opto Output configured as normally closed
Chapter 4
Maintenance
www.aerotech.com