Analog I/O Board Option [Archive] - Aerotech Npaq DL 4010 Series Hardware Manual

Options

3.5. Analog I/O Board Option [Archive]

N O T E : This option is no longer available for purchase. This section is for legacy users.
The Analog I/O board adds four 16-bit analog inputs and six 16-bit analog outputs to the Npaq. Both inputs
and outputs have a fixed range of ±10V and are updated at a 1 kHz rate. These ranges may not be exceeded
or damage may occur. It is not possible to change the input voltage range via parameters.
N O T E : The presence of the Analog I/O Board Option requires the use of several of the high-speed I/O.
When the analog I/O board is installed, the following I/O are no longer available for user I/O: HSOUT12,
HSOUT13, HSIN19, HSIN20, HSIO14, and HSIO15.
Table 3-6: Analog I/O Board Connector Pinout (J80)
Pin # Description
1 Shield
2 Analog Out 5
3 Analog Out 7
4 Analog Out 9
5 Ground
6 +5V
7 Ground
8 +3.3V
9 Analog Input 6+
10 Analog Input 7+
11 Analog Input 4+
12 Analog Input 5+
13 Ground
14 Analog Out 4
15 Analog Out 6
16 Analog Out 8
17 Ground
18 +12V
19 Ground
20 -12V
21 Ground
22 Analog Input 6-
23 Analog Input 7-
24 Analog Input 4-
25 Analog Input 5-
Table 3-7: Mating Connector Part Numbers for the Analog I/O Connector (J80)
Mating Connector
25-Pin D-Connector
Backshell
www.aerotech.com
Refer to
Refer to
Refer to
Aerotech P/N
ECK00101
ECK00656
Chapter 3
Npaq® Hardware Manual
In/Out/Bi Connector
--
Output
Output
Output
Section
3.5.1.
Input
Input
Input
Input
Section
3.5.1.
Output
Output
Output
Section
3.5.1.
Input
Input
Input
Input
Third Party P/N
FCI DB25P064TXLF
Amphenol 17E-1726-2
99