Electrical Specifications; Table 1-3: Chassis Electrical Specifications - Aerotech Npaq DL 4010 Series Hardware Manual

Introduction

1.1. Electrical Specifications

The electrical specifications for the Npaq drive chassis are listed in
specifications for the servo amplifiers in
N O T E : Specifications represent the maximum capability of a feature. Other system constraints may res-
ult in significantly less performance. This is particularly applicable to the motor output specifications. The
motor output specifications are affected by the Bus supply, the number of axes that are operating at the
same time, the type of motion, the AC Line voltage, and motor requirements.
Table 1-3: Chassis Electrical Specifications
Description
Bus Voltage Options
100 VAC
115 VAC
Input
Current
200 VAC
230 VAC
AC Power Input
Auxiliary Power Outputs
Protection
Isolation
Indicator (Power)
Indicator (Enabled)
www.aerotech.com
Table 1-4.
Specification
10B, 20B, 30B, 40B, 80B, 160LT & 320LT [Factory Configured]
10 A Maximum
10 A Maximum
5 A Maximum
5 A Maximum
AC input (Switch Selectable): AC Hi, AC Lo, Earth Ground ( ),
100 VAC (90-112 VAC, 50/60 Hz)
l
115 VAC (103-127 VAC, 50/60 Hz)
l
200 VAC (180-224 VAC, 50/60 Hz)
l
230 VAC (207-254 VAC, 50/60 Hz)
l
Note: If the Npaq contains an offline Bus power supply, the AC Input will be limited to one AC
input range.
+5 Volts is provided on all axis feedback connectors for encoder, Hall, and
limit power.
AC power cord serves as the mains breaker (10 A, Supplemental
Protection only).
Internal Bus supply fusing.
Amplifier Output short circuit protection.
Peak and RMS over current limit.
Over Temperature shutdown.
Bus supply inrush current limit during initial power-on.
Opto and transformer isolation between control and power stages.
Power switch contains a power-on indicator.
Individual Amplifier LED's indicates drive enabled state.
Chapter 1
Npaq® Hardware Manual
Table 1-3 and the electrical
21