Power Configuration For The -Aio Option [Archive] - Aerotech Npaq DL 4010 Series Hardware Manual

Npaq® Hardware Manual

3.5.1. Power Configuration for the -AIO Option [Archive]

N O T E : This option is no longer available for purchase. This section is for legacy users.
The default wiring for the analog I/O board is the non-isolated configuration. In this configuration, the board
draws its power from an internal power supply. J80 pins 5, 6, 7, 8, 13, 17, 18, 19, 20, and 21 are internally
connected to the internal power supply.
Alternatively, the board can be wired to use the isolated configuration. In this configuration, an external
power supply provides power to the board through J80 pins 5, 6, 7, 8, 13, 17, 18, 19, 20, and 21.
shows the power requirements for the external power supply. This wiring configuration is a factory option and
should be specified at the time of the purchase.
Table 3-8: External Power Supply Specifications
Supply Voltage
+3.3V
+5V
+12V
-12V
Common
100
Maximum Current
320 mA
50 mA
60 mA
60 mA
-
Chapter 3
Options
Table 3-8
J80 Pin #
8
6
18
20
5, 7, 13, 17, 19, 21
www.aerotech.com