Npaq® Hardware Manual
2.2. Electrical Installation
Motor, power, control and position feedback cable connections are made to the rear of the Npaq.
A combination power switch/circuit breaker is located on the front of the Npaq. This breaker is connected to
the incoming AC power and provides protection to the Npaq system in case of severe overloads. This
breaker is selected to meet the maximum current requirements of the Npaq system and is normally a 10 A
breaker.
30
Figure 2-1:
Power and Control Connections
Figure 2-2:
Chapter 2
Installation and Configuration
Power Switch
www.aerotech.com