Analog Inputs (J10); Figure 2-41: Analog Inputs (J10); Table 2-43: Differential Analog Input 1 Specifications (J10); Table 2-44: Analog Input Pins On The Analog I/O Connector (J10) - Aerotech Npaq DL 4010 Series Hardware Manual

Installation and Configuration

2.10.2. Analog Inputs (J10)

To interface to a single-ended (non-differential) voltage source, connect the signal common of the source to
the negative input and the analog source signal to the positive input. A floating signal source should be
referenced to the analog common as shown in
Table 2-43: Differential Analog Input 1 Specifications (J10)
Specification
(AI+) - (AI-)
Resolution (bits)
Resolution (volts)
1. Signals outside of this range may damage the input
Table 2-44: Analog Input Pins on the Analog I/O Connector (J10)
Pin # Description
1 Analog Input 0+
2 Analog Input 1+
3 Analog Input 2+
4 Analog Input 3+
7 Analog Ground
8 Analog Ground
9 Analog Input 0-
10 Analog Input 1-
11 Analog Input 2-
12 Analog Input 3-
15 Analog Ground
www.aerotech.com
Figure 2-41.
+10 V to -10 V
Figure 2-41: Analog Inputs (J10)
Chapter 2
Npaq® Hardware Manual
Value
(1)
16 bits
305 µV
In/Out/Bi
Input
Input
Input
Input
N/A
N/A
Input
Input
Input
Input
N/A
77