Transponder Processing - Siemens SIMATIC RF650R Configuration Manual

Parameter
Parameter
value_id
value_
source Name
value_
antennaName
10.3.3

Transponder processing

This section describes all the commands with which you can control the processing of the
transponder data. There are two ways of querying transponder data:
● Synchronous transponder command
Commands that return the transponder data in the reply frame.
The reader executes the required action once and then sends back the acquired
transponder data.
Algorithms that work with individual transponder commands such as
"Read/WritePowerBoost" and "Read/WriteRetry" are active.
● Asynchronous transponder events
"TagEventReports" are sent by the reader to the user application on the reader's
initiative.
The transponder data is acquired only by triggers of the read point. The configuration of
the reader opens up numerous options for the trigger configuration of a read point.
You specify the message content contained in the reply frames using the tag events in the
WBM. You will find more information on the tag events in the section "The "Settings -
Communication" menu item (Page 74)".
SIMATIC RF650R/RF680R/RF685R
Configuration Manual, 03/2018, C79000-G8976-C386-06
Type Values
Decimal value 0...4294967295
0...9
Text --
Fixed value Antenna01
Antenna02
Antenna03
Antenna04
Programming via XML interface
10.3 XML commands
Description
Unique command identifier
Name of the read point The name is
set via the WBM (see section "The
"Settings - Read points" menu item
(Page 54)"). In the standard configura-
tion, there is only one read point with
the name "Readpoint_1".
Optional
Name of the antenna
221