Siemens SIMATIC RF650R Configuration Manual page 37

The following table provides an overview of all configurable reader parameters:
Table 5- 1
Parameter
General
PROFINET interface [X1]
General
Ethernet addresses
Advanced options
Web Based Management
Module parameters
Configuration management
RFID communication
General
I/O addresses
Digital inputs/outputs
General
I/O addresses
SIMATIC RF650R/RF680R/RF685R
Configuration Manual, 03/2018, C79000-G8976-C386-06
Configurable parameters of the reader
Functionality
General settings of the reader
All settings of the PROFINET interface
Name of the PN interface
Setting of the IP address and device name
Advanced PROFINET options such as update time, port settings,
belonging to an MRP domain etc.
Starting the WBM of the reader
Note: The WBM can only be started if either the PROFINET con-
nection between the CPU and reader is established or the reader
was assigned the IP address stored in the project. This means that
the device name has been assigned and the TIA configuration
must be loaded on the SIMATIC controller.
Enabling/disabling read point-related diagnostics messages.
Loading configuration data on the reader from the STEP 7
•
project.
Saving configuration data of the reader in the STEP 7 project.
•
Address parameters of the reader
General settings
I/O address parameter ("LADDR") of the reader. This parameter is
used in the "IID_HW_CONNECT" variable.
Address parameters of the digital inputs/outputs of the reader.
General settings
I/O address parameter of the digital inputs/outputs.
Using the set address range (I/O address), the digital in-
puts/outputs configured in the WBM of the reader can be ac-
cessed.
Configuration via STEP 7 (PROFINET device)
5.3 Overview of the configurable properties
37