Siemens SIMATIC RF650R Configuration Manual page 264

Programming via XML interface
10.3 XML commands
Parameter
Parameter
value_id
value_resultCode
value_name
value_cause
List of possible result codes
Result code
hex
0x00
0x13
0x1A
0x91
0x92
0x93
0x94
0x95
0x22
0xA1
0xA2
0xA3
0xA5
0xA6
0xA7
0xA8
0x41
264
Type
Decimal value
0...9
Decimal value
0...9
Text
Text
Name
dec
0 NO_ERROR
19 ERROR_MEMORY_OVERRUN
26 ERROR_TAG_LOCKED
145 ERROR_NO_ASWER_FROM_TAG
146 ERROR_WRONG_PASSWORD
147 ERROR_VERIFY_TAG_FAILED
148 ERROR_TAG_UNSPECIFIED
149 ERROR_TAG_INSUFFICIENT_
POWER
34 ERROR_TOO_MANY_TAGS
161 ERROR_NO_TAG
162 ERROR_NO_DATA
163 ERROR_INVALID_CRC
165 ERROR_NO_FREQUENCY
166 ERROR_NO_CARRIER
167 ERROR_MORE_THAN_ONE_
TAG_IN_FIELD
168 ERROR_AIR_PROTOCOL_
UNSPECIFIED
65 ERROR_POWER_SUPPLY
Values Description
0...4294967295 Unique command identifier
0...65535 Identification number of the error
You will find a list of possible return
codes in the following table.
-- Textual description of the error
You will find descriptions of the prob-
lems in the following table.
-- Brief description of the cause of the
negative reply.
Description
Positive reply, command processed suc-
cessfully.
Access outside the addressed memory
area.
The transponder to which data is meant to
be written or which should be deactivated is
locked.
The transponder is not responding.
The password you entered is incorrect.
Access to the transponder was denied.
Verification of the transponder failed.
General transponder error.
There is not enough transponder power.
There are too many transponders in the
antenna field.
There is no transponder with the relevant
EPC-ID in the antenna field.
The requested data is not available.
Bad checksum
No radio channel activated.
No carrier signal activated.
There is more than one transponder in the
antenna field.
General radio protocol error
Fault in power supply.
Configuration Manual, 03/2018, C79000-G8976-C386-06
SIMATIC RF650R/RF680R/RF685R