Programming via XML interface
10.3 XML commands
10.3.2.16
getAntennas
The command returns all antennas that are configured at the specified read point.
This command is supported as of API protocol version V2.1.
Command
<frame>
<cmd>
</cmd>
</frame>
Reply
<frame>
<reply>
</reply>
</frame>
// opt → Optional: Line can be omitted.
The error codes for negative replies ("resultCode" ≠ 0) are described in the section "Negative
XML replies (Page 263)".
220
<id> value_id </id>
<getAllAntennas>
<sourceName> value_ sourceName <sourceName>
</getAllAntennas>
<id> value_id </id>
<resultCode> 0 </resultCode>
<getAllAntennas>
<returnValue>
<antennaName> value_antennaName </antennaName>
...
<antennaName> value_antennaName </antennaName>
</returnValue>
</getReaderStatus>
SIMATIC RF650R/RF680R/RF685R
Configuration Manual, 03/2018, C79000-G8976-C386-06
// opt