Interrupts - Siemens SIMATIC RF650R Configuration Manual

Programming via XML interface
10.4 XML EventReports
10.4.2

Interrupts

This section describes all alarms. Alarms are asynchronous messages and are used as
status, warning or error messages of the reader.
The meaning of an alarm is indicated by the error number and other optional parameters.
Report
<frame>
<alarm>
</alarm>
</frame>
// opt → Optional: Depending on the parameter assignment or the amount of data, the line
can be omitted.
Reply
<frame>
<reply>
</reply>
</frame>
The error codes for negative replies ("resultCode" ≠ 0) are described in the section "Negative
XML replies (Page 263)".
Parameter
Parameter
value_id
value_
errorNumber
274
<id> value_id </id>
<error>
<utcTime>value_utcTime </utcTime>
<errorNumber>value_errorNnumber </errorNumber>
<errorText>value_errorText </errorText>
<eventType>value eventType </eventType>
<paramXY>value_param_xy </paramXY>
...
</error>
<id> value_id </id>
<resultCode> 0 </resultCode>
<error/>
Type
Decimal value
0...9
Decimal value 0 -
9
Values Description
0...4294967295 Unique command identifier
0...65535 Error number
You will find a list of error numbers in
the following table.
Configuration Manual, 03/2018, C79000-G8976-C386-06
// opt
// opt
SIMATIC RF650R/RF680R/RF685R