8.5.2.5
Set_Param
With the "Set_Param" block, you can change UHF parameters on an RF680R/RF685R
during runtime (e.g. the antenna power).
Note
Settings saved only temporarily
Note that the parameters in the "Set_Param" block are only stored temporarily. If the power
for the reader is interrupted, the stored values are lost and must be set again.
Figure 8-15
Table 8- 15
Parameter
PARMID
VALUE
SIMATIC RF650R/RF680R/RF685R
Configuration Manual, 03/2018, C79000-G8976-C386-06
"Set_Param" block
Explanation of the "Set_Param" block
Data type
DWORD
DWORD
Programming via SIMATIC controller
Default values
Description
0x00
Parameter identifier
0x00
Parameter value
8.5 Programming Ident blocks
131