Siemens SIMATIC RF650R Configuration Manual page 301

Backup on the controller
Using the "Config_Upload" and "Config_Download" blocks, you can read out
("Config_Upload") or write ("Config_Download") the configuration of the RF680R/RF685R
readers via the control program. Since the configuration is stored permanently, you need to
reserve a data block for this on the controller.
To ensure the configuration is correct, you can read the version ID (Config ID) of the reader
with the reader status and compare this to the Config ID that was stored earlier in the
controller with the "Config_Upload" command in the data block.
You will find further information on programming the blocks and the structure of the
configuration data in the section "Config_Upload/-_Download (Page 123)".
Backup into a STEP 7 project
From the device view of the TIA Portal, you can access the "Properties" tab of the reader.
When configuring with HSP, in the "Configuration management" entry, you can save the
configuration of the reader in your project and also load this on the reader again.
Requirement
● The "PROFINET interface [X1]" entry contains the correct IP address of the reader.
● The user name and corresponding password have been entered correctly.
● The entered user has the required rights to run the download/upload (refer to the section
"The "User management" menu item (Page 102)").
Note
User name and password only necessary if user management is enabled
The "User name" and "Password" text boxes only need to be completed if the user
management of the WBM is enabled.
Following the upload/download, the status bar indicates whether the action was completed
successfully.
Figure 12-4
SIMATIC RF650R/RF680R/RF685R
Configuration Manual, 03/2018, C79000-G8976-C386-06
Successful upload of the configuration
Service and maintenance
12.3 Module replacement
301