Siemens SIMATIC RF650R Configuration Manual page 252

Programming via XML interface
10.3 XML commands
</reply>
</frame>
// opt → Optional: Line can be omitted. In the reply, the parameter is transferred depending
on the configuration settings (engineering/communication).
The error codes for negative replies ("resultCode" ≠ 0) are described in the section "Negative
XML replies (Page 263)".
Parameter
Parameter
value_id
value_
sourceName
value_tagID
value_tagPC
value_fieldName
252
</tag> // opt
</returnValue>
</writeTagField>
Type
Decimal value
0...9
Text
Hexadecimal
value
0...9, A...F
Hexadecimal
value
0...9, A...F
Hexadecimal
value
0...9, A...F
Values Description
0...4294967295 Unique command identifier
-- Read point name
The name is specified using the WBM
(refer to the section "The "Settings -
Read points" menu item (Page 54)").
In the standard configuration, there is
only one read point with the name
"Readpoint_1".
-- Optional
EPC-ID in "RAW Hex Data Format".
This function applies to all transpond-
ers with this ID.
If this parameter is empty or not even
transferred, the function applies to all
transponders. Nevertheless only one
transponder is then permitted in the
antenna field.
Example of a 96-bit EPC-ID:
3005FB63AC1F3681EC880468
For additional information, refer to the
"EPC Global Specification".
-- Optional
Tag PC (Protocol Control)
16-bit value represented by four hexa-
decimal characters.
Example:
The value "1234" corresponds to the
binary value "0001.0010.0011.0100".
-- Name of tag field
Is specified using the WBM.
Configuration Manual, 03/2018, C79000-G8976-C386-06
SIMATIC RF650R/RF680R/RF685R