SMC Networks EX600-SEC Series Operation Manual page 47

•Digital I/O unit parameters (2)
Parameter
No.
(H.T. Symbol)
Output setting
Set output per
for
channel during
9 communication
communication
∗ 2
idling
idling.
(Idle_MD)
Memorizes the
number of times
Input or the input or output
Output device is ON.
10 ON/OFF Generates error
counter per channel when
(Counter) the operation count
exceeds the set
value.
∗1: Could be incorrectly recognized as short circuit depending on used load (ex.: lamp load). If detection is incorrect, disable the
parameter setting.
∗2: This master is valid only when "Hold/Clear priority" of the system parameter is set to Handheld.
∗3: The count is memorized every hour. When the power supply is turned on again, counting starts from the last value memorized.
∗4: Times for setting is set value x1000 times.
Definition Item
Clear
Hold
ForceON
Enable
Disable
∗ 3
Content
Turn off the output
Hold the output
Turn on the output
forcefully
Generates an error.
∗ 4
Val: 1 to 65000
Does not generate an
error.
-46-
Parameter
setting
Default
By
setting
By
Ether
H.T.
CAT
○
○ ○
○ ○
○
No.EX##-OMO0027