Parameter Setting - SMC Networks EX600-SEC Series Operation Manual

Parameter Setting

The product has parameters that can be set for the system, each unit or each channel.
The parameters can be changed using the PLC and handheld terminal.
There is no order of precedence of the PLC and handheld terminal. The latest parameter settings are used.
●Precautions for handling
•Changing parameters with the H.T. does not change the parameter settings in the PLC.
•If parameters are downloaded from the configuration to the PLC after changing parameters
with the H.T., parameters will be changed to those which are set by the configuration.
Therefore, set parameters by PLC if the parameters can be changed by both PLC and H.T.
•The H.T. have to use EX600-HT1A. (EX600-HT1 cannot be used.)
■Parameter definition and setting
•System parameters
Parameter
No.
(H.T. Symbol)
Switch the setting
of the output during
communication
Hold/Clear error or
1 priority setting communication
(Hold/Clear) idling to follow the
setting of the SI
unit or the
parameters.
Definition Item
Switch
Handheld
Content
Setting by SI unit switch
becomes valid.
OFF/Hold/Forced ON can
be set per channel
Setting by parameters or
the H.T. becomes valid.
OFF/Hold/Forced ON can
be set per channel.
-40-
Parameter
setting
Default
By
setting
By
Ether
H.T.
CAT
○
○ ○
No.EX##-OMO0027