Enter/Exit Programming Mode
UPC-E Number System Character Transmission
Enables/disables transmission of a UPC-E number system character.
To set this feature:
1. Scan the Enter/Exit Programming Mode barcode at the top of the page.
2. Scan either the enable or disable barcode below. You'll need to cover any
3. Complete the programming sequence by scanning the Enter/Exit Pro-
024801(CR)
UPC-E Number System Character Transmission = Enable
126
This item is ignored when the advanced feature, Full Label Edit, is
enabled.
NOTE
unused barcodes on this and the facing page to ensure that the scanner
reads only the barcode you intend to scan.
gramming Mode barcode.
UPC-E Number System Character Transmission
024800(CR)
UPC-E Number System Character Transmission = Disable
DEFAULT
Magellan™ 1500i