EAN-8 Check Character Transmission
EAN-8 Check Character Transmission
Enables/disables transmission of an EAN/JAN-8 check character.
To set this feature:
1. Scan the Enter/Exit Programming Mode barcode at the top of the page.
2. Scan either the enable or disable barcode below. You'll need to cover any
3. Complete the programming sequence by scanning the Enter/Exit Pro-
00B801(CR)
EAN-8 Check Character Transmission = Enable
Product Reference Guide
This item is ignored when the advanced feature, Full Label Edit, is
enabled.
NOTE
unused barcodes on this and the facing page to ensure that the scanner
reads only the barcode you intend to scan.
gramming Mode barcode.
Enter/Exit Programming Mode
00B800(CR)
EAN-8 Check Character Transmission = Disable
DEFAULT
137