Double Read Timeout - Datalogic Magellan 1500i Product Reference Manual

2D Double Read Timeout
2D Double Read Timeout
The 2D Double Read Timeout feature specifies the minimum allowable time
which must pass before reading the same 2D label again (e.g. two identical
items in succession).
To set this feature:
1. Scan the Enter/Exit Programming Mode barcode at the top of the page at
2. Scan your selection from the barcodes below. You'll need to cover any
3. Complete the programming sequence by scanning the Enter/Exit Pro-
03DF1E(CR)
2D Double Read Timeout = 300ms
03DF3C(CR)
2D Double Read Timeout = 600ms
DEFAULT
03DF50(CR)
2D Double Read Timeout = 800ms
Product Reference Guide
the top of the page.
unused barcodes on this and the facing page to ensure that the scanner
reads only the barcode you intend to scan.
gramming Mode barcode.
If the incidence of multiple reads is not acceptable, increase the
Timeout setting to a higher value.
NOTE
Enter/Exit Programming Mode
03DF28(CR)
2D Double Read Timeout = 400ms
03DF46(CR)
2D Double Read Timeout = 700ms
17