Usb Interface Features; Usb-Com Interface Setup; Usb Power Compliance - Datalogic Magellan 1500i Product Reference Manual

USB-COM Interface Setup

USB Interface Features

USB-COM Interface Setup
The Datalogic USB-COM driver is required to use USB-COM or USB-COM DL
interfaces. The Datalogic USB-COM driver can be downloaded from the Data-
logic website.
Before plugging your scanner into the Host PC, please ensure you have already
copied the executable DLS USB-COM driver file to your PC and that the scan-
ner's interface is set to USB COM or USB COM DL.
1. Execute the DLS USB-COM driver file.
2. When the scanner is first plugged into the PC, Windows will bring up the
3. The installation is complete.

USB Power Compliance

This feature enables / disables the ability of the Universal Interface to hold off
system controller power until after USB POS Host enumeration.
To set this feature:
1. Scan the Enter/Exit Programming Mode barcode at the top of the page.
2. Scan the desired option from the barcodes below. You'll need to cover any
3. Complete the programming sequence by scanning the Enter/Exit Pro-
150F01(CR)
USB Power Compliance = Enable
Product Reference Guide
"Found New Hardware" message.
unused barcodes on this and the facing page to ensure that the scanner
reads only the barcode you intend to scan.
gramming Mode barcode.
Enter/Exit Programming Mode
150F00(CR)
USB Power Compliance = Disable
DEFAULT
71