Getting Started; Programming Mode - Datalogic Magellan 1500i Product Reference Manual

About Programming your Scanner

Getting Started

After scanning the interface barcode from the
tion, you can select other options and customize your scanner through use of
the instructions and programming barcodes available in that section and also
the Data Editing

Programming Mode

Scan the Enter/Exit Programming Mode barcode found at the top of applicable
pages) once to enter Programming Mode. After the scanner is in Programming
Mode, you can scan a number of parameter settings before scanning the Enter/
Exit Programming Mode barcode a second time, which will then accept your
changes, exit Programming Mode, reset the scanner and return it to normal
operation.
The scanner will exit Programming Mode under any of the following conditions:
While in Programming Mode, the scanner only recognizes the special program-
ming bar codes contained in this programming guide. See
information about scanner indications while in the Programming Mode.
Some programming barcode labels, like the label
scan of that single label to enact the change. Most of the programming labels in
this manual, however, require the scanner to be placed in Programming Mode
prior to scanning them.
1. Exception: If an interface bar code had been read while in Programming Mode, the
10
and 1D Symbologies
When you program the scanner using any of the methods above, the
scanner will store the changes until reprogrammed or returned to fac-
tory defaults.
NOTE
While in Programming Mode, your scanner will read the 2D program-
ming bar codes in this manual regardless of whether 2D reading capa-
bility has been enabled as an option.
NOTE
— the programming sequence has been completed or the Enter/Exit Pro-
gramming Mode bar code is scanned.
— five minutes have passed without scanning activity. Any data pro-
grammed during the current session will be ignored, and the scanner
will reset and revert to its condition previous to initiating the exited ses-
sion.
— power is disconnected. Disconnecting power during Programming
Mode, before scanning the Enter/Exit Programming Mode bar code, will
cause all new settings to be ignored
return to previous settings.
scanner will operate on the default settings for the new interface.
Interface Related Features
chapters of this manual.
1
. On powerup, the scanner will
on page
sec-
Appendix A for
14, require only the
Magellan™ 1500i