Accelerometer Delay To Stationary - Datalogic Magellan 1500i Product Reference Manual

Enter/Exit Programming Mode

Accelerometer Delay To Stationary

Sets amount of time the scanner will remain in Scanner Active Mode/Handheld
State following the last valid detected motion.
1. Scan the Enter/Exit Programming Mode barcode at the top of the page.
2. Scan the barcode
3. Scan the appropriate digits from the
4. Scan the Enter/Exit Programming Mode barcode at the top of the page to
DEFAULT
30
Accelerometer Delay To Stationary
cover any unused barcodes on this and the facing page to ensure that the
scanner reads only the barcode you intend to scan.
that represent the desired time interval. The selectable range is 00-255, in
10 millisecond increments.
exit Programming Mode.
Accelerometer Delay To Stationary
below. You'll need to
Alpha-Numeric Keypad in Appendix C
1508(CR)
Accelerometer Delay To Stationary
Default setting for this feature is: 150 mS
Magellan™ 1500i