Advertisement
MAS Requirements
PBX hardware requirements
PBX software requirements
AVAYA E1/QSIG
2.0 AVAYA MESSAGE APPLICATION SERVER REQUIREMENTS
•
Dialogic D/600JCT-1E1 or D/300JCT-E1
•
CT Bus cable (only required for multiple card installation)
•
Supported Releases: 1.1, 2.0, 3.0, 3.1, 4.0, 5.0, 5.1
3.0 PBX HARDWARE REQUIREMENTS
•
TN464 or MM710 circuits one per each Dialogic E1 Interface Card
•
Cables:
-RJ45 on the Dialogic (cable depends on PBX connection)
3.1 PBX SOFTWARE REQUIREMENTS
• Minimum Supported Software:
Definity G3 & Prologix: G3V10.1 Load 43
S8300/S8xx0: MV1.1, CM2.0 / 3.1.x / 4.x / 5.x
Important: Before ordering account teams should check with Avaya
Services to determine if there are any applicable patches for customer
specific configuration. Specifically if DCS+ or QSIG Networking is used.
•
ISDN PRI
•
Private Networking
•
Basic Call Setup
•
Basic Supplementary Services
•
Supplementary Services with Rerouting
DCS+ for Multiple PBX Support (Refer to Section 9.0)
●
(This option is only required for networking (multiple PBXs)
Note: Either DCS+ or QSIG Networks are necessary to support multiple
PBXs (Centralized Voice Mail). No other networks are supported.
Refer to Section 8.0 (Considerations) for additional info.
The above information is provided by AVAYA Inc. as a guide. See disclaimer on page 1
2
Advertisement
