Speedometer Calibration - Mercury 225 EFI Service Manual

WIRING DIAGRAMS
CALIBRATION
TRIM CALIBRATION
CALIBRATION
TRIM FULL UP
THEN PRESS PLUS (+) BUTTON
[DFLT]
CALIBRATION
TRIM TO TRAILER POINT
THEN PRESS PLUS (+) BUTTON
[DFLT]
CALIBRATION
TRIM FULL UP
THEN PRESS PLUS (+) BUTTON
[DFLT]
CALIBRATION
EXIT ?
[ NO ]

Speedometer Calibration

Simple Calibration – This calibration for setting lighting and setting the clock can be
made while engine is running.
1. Press in the
2. Press
Advanced Calibration – This calibration goes through the entire mode selections.
1. Turn ignition key to the off position.
2. Hold
3. Press and hold
4. Press
CALIBRATION
BRIGHTNESS
[DOWN]
CALIBRATION
BRIGHTNESS
SET ALL INSTRUMENTS?
[ NO ]
CALIBRATION
CONTRAST
[DOWN]
CALIBRATION
CONTRAST
SET ALL INSTRUMENTS?
[ NO ]
Page 2D-64
[SKIP] [EDIT]
[SAVE]
[SKIP]
[SAVE]
[SKIP]
[SAVE]
[SKIP]
[ YES ]
TROLL
MODE
and
MODE
to advance through the calibration selections.
TROLL TROLL
and turn ignition key to the on position.
+ –
MODE
for 2 seconds to bring up the calibration screen.
MODE
to advance through the calibration selections.
[SAVE]
[ YES ]
[SAVE] [UP]
[ YES ]
If the trim setting is not reading correctly, the trim sensor can
be re-calibrated to correct the setting.
Pressing DFLT (default) during edit will return to original value
setting
Press MODE to skip to the next display. Press + (edit) to cali-
brate the sensor.
1. Trim outboard full up, than Press + to save.
2. Trim outboard to the point where the trim cylinders takes over,
than Press + to save.
3. Trim outboard full down, than Press + to save.
Do you want to exit the calibration mode? Press + for yes.
Press MODE for no.
buttons for calibration screen.
+
Press – or + to adjust level. Press MODE to save setting
[UP]
Do you want the same brightness level for all SmartCraft
gauges? Press + for yes. Press MODE for no.
Press – or + to adjust level. Press MODE to save setting
Do you want the same contrast level for all SmartCraft
gauges? Press + for yes. Press MODE for no.
90-884294 OCTOBER 2001