Throttle Cable; Installation - Mercury 225 EFI Service Manual

Throttle Cable

INSTALLATION

1. Position remote control into neutral.
2. Attach throttle cable to the throttle lever. Secure with washer and locknut.
3. Adjust the cable barrel so that the installed throttle cable will hold the idle stop screw
against the stop.
90-884294 OCTOBER 2001
a - Nylon Washer
b - Locknut – Tighten locknut then back off locknut 1/4 turn
a - Cable Barrel – Adjust To Hold Idle Stop Screw Against Stop
b - Idle Stop Screw
N
a
b
a
POWERHEAD
b
Page 4A-85