Mercury 225 EFI Service Manual page 215

CALIBRATION
[SKIP]
CALIBRATION
TIME FORMAT
12H – M,D,Y, or 24H – D,M,Y
[DOWN] [SAVE]
CALIBRATION
ENABLE or DISABLE
DOWN] [SAVE]
[
CALIBRATION
UTC ZONE
UTC CORRECTION = X H
[DOWN] [SAVE]
CALIBRATION HOUR
4:15
[DOWN] [SAVE]
CALIBRATION MINUTE
4:15
[DOWN] [SAVE]
CALIBRATION
EXTERNAL SENSORS
[SKIP]
CALIBRATION
EXTERNAL SENSORS
AIR SENSOR SENSOR ? YES/NO
[DOWN] [SAVE]
CALIBRATION
EXTERNAL SENSORS
GPS CONNECTED ? YES/NO
[DOWN]
If YES was saved
CALIBRATION
EXTERNAL SENSORS
USE GPS SPEED ? YES/NO
[DOWN]
CALIBRATION
EXIT ?
[ NO ]
90-884294 OCTOBER 2001
TIME
[EDIT]
NMEA
PM
PM
[EDIT]
[UP]
[SAVE] [UP]
[SAVE] [UP]
[ YES ]
If the clock display is correct , press MODE to skip.
To set or reset the clock Press +
Select 12 hour or 24 hour clock set.
Press – or + to select. Press MODE to save.
Press – or + to enable or disable GPS time calibration. If a GPS
[UP]
navigation receiver is connected to the gauges, NMEA data
will set the time automatically. Press MODE to save.
Press – or + to add UTC correction. MODE to save. (Hour off-
[UP] set from universal time constant)
Press – or + to set the hour
Press MODE to save.
[UP]
Press – or + to set the minute
Press MODE to save.
[UP]
[UP]
Press MODE to skip to the next display. Press + (edit) if your
adding or deleting any external sensor to the SmartCraft Sys-
tem.
Editing External Sensors
Chose Yes or No for each sensor
No = not used Yes = in use
Press + or – for correct setting
Press MODE to save and advance to next sensor
Chose Yes or No if you want the speedometer
to read GPS speed
Do you want to exit the calibration mode? Press + for yes.
Press MODE for no.
WIRING DIAGRAMS
Page 2D-65